![]() ![]() Several people have asked me that - Webasto have never included that information in their literature for some reason. The pump cable slides into the slot in the combustion air intake then the pipe is just pushed up to it and clamped in position - it doesn't need to be airtight. I've got my van booked in for the end of the month to drop the wheelchair lift, to access the fuel pump assembly, i looked at all my other options, but i don't have the time to get them done by the end of the month. I'm assuming it is the pump cable, and i'm assuming that i drill out a section of the hose and feed the cable through it and then clamp below it and then seal the entry hole?Īny help will be good, as this won't be the only question, as the electrical side seems confusing to me with this item. So i have already drilled the 140mm hole, primed and installed rivnuts for the Stainless base, cables are run, multi control panel is fitted in place.īut nothing in the instructions show or explain the cable in the air inlet. ![]() I've come to installing the diesel heater, and the instructions from Webasto aren't the easiest. Not sure if this is the right place for this thread, but i wasn't sure, so Pauly please move it if it needs to be in a different area.Īs some of you know i've been building my camper, in the camper van build thread.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |